Advertisement
NXT:
Press this button to go forward to the beginning
of
the next selection. Press NXT again or press RCL, or
STOP to cancel this function. If you press RCL, the tape
will also change sides.
PRV: Press this button to go back to the beginning
of
the last selection. Press the button again or press RCL,
or STOP to cancel this function.
For NXT and PRV to work properly, your tape must
have at least three or four seconds of silence between
each selection. If you press RCL, the tape will
also
change sides.
RPT: Press this button to go to the beginning of
the
selection and play it again. Press RPT again
to cancel
this function.
Noise Reduction: Press the button with the double-D
symbol to remove noise from tapes encoded with
Dolby NR.
Dolby Noise Reduction is manufactured under a license
from Dolby Laboratories Licensing Corporation. Dolby
and the double-D symbol are trademarks of Dolby
Laboratories Licensing Corporation.
RDM: When playing a tape, press this button during FF
or REW to hear the radio. Press it again to turn the radi
off. During this operation, only TUNE, SEEK and
PSCAN will work.
RCL: Press this button to switch from one side of the
tape to the other.
STOP: Press this button to stop the tape and switch to
the radio.
EJECT: Press this button to remove the tape and switch
to the radio.
CLN: This message may appear on the display. If it
does, your cassette tape player needs to be cleaned.
It
will still play tapes, but you should clean it as soon as
possible to prevent damage to your tapes and player.
See "Care of Your Cassette Tape Player" in the Index.
After you clean the player, press and hold EJECT
for
five seconds to reset
the
CLN indicator. The radio will
display
---
to show the indicator was reset.
3-13
Advertisement
