Pantech Verse Quick Start Manual page 5

3. Align the cover tabs with the slots on the back of the device and
slide the battery cover onto the unit until it snaps into place.
Charging your Battery
1. Connect the USB data cable into the cabless wall
adapter.
2. Plug the USB data cable into the phone' s
Charging/Data Port (making sure to align the
connector as it appears in the image to the right)
and the wall adapter end into an electrical outlet.
• If the battery connector is not properly aligned, damage could occur to
Note:
the charging connector and the phone may not charge.
• The main plug is used as the disconnect device and remains readily
operable.
Correct
Correct
6
Incorrect
Incorrect
3. To remove the Wall Charger, gently pull the
charger from the device.
• When you charge the battery with the handset
Note:
powered off you will see a charging status screen.
After the charging has completed, the Charge
Complete message appears. You cannot operate
the phone until is powered on. To turn your phone on, press and hold
the END/POWER Key until your display turns on.
• The battery is not fully charged at the time of purchase. Fully charge the
battery before use.
• It is more efficient to charge the battery with the handset powered off.
Battery operating time gradually decreases over time.
If the battery fails to perform normally, you may need to replace the
battery.
Please use only an approved charging accessory to charge your
WARNING!
device. Improper handling of the charging port, as well as the use of an
incompatible charger, may cause damage to your device and void the warranty.
BASICS
7