Daytime Room Temperature" Key; Night-Time Room Temperature" Key - Honeywell SDC Operating Instructions Manual

Operation

4.1.2.2 "Daytime Room Temperature" Key

ROOM-DAY
æ ç è é ê ë ì í

4.1.2.3 "Night-time Room Temperature" Key

rices and delivery to your door visit MyTub Ltd - 0845 303 8383 - www.mytub.co.uk - info@mytu
¥
c
o
22. 0
Factory setting
Setting range
¦
•
Shift to the menu selection level
•
Get one menu level higher
By turning the rotary pushbutton, you can:
•
Change values (clockwise increases values, counter-
clockwise decreases values)
•
Browse through menus
This key sets the room temperature setpoint in the
automatic program during the heating cycles as well as
during the PARTY and HEATING operating modes. In
control mode 1, the setpoint is identical for all the heating
circuits. In control mode 2, the setpoint can be individual
for all circuits. To change the control mode, see "Mode"
section
Setting:
Press the "daytime room temperature" key ¥.
►
Set the flashing room temperature default value by
►
turning the rotary pushbutton î to the desired value.
Confirm the set value by pressing either the "daytime
►
room temperature" key ¥ key or the rotary
pushbutton î.
Alternatively, the value can be acquired by automatic
►
exit after the set INFO-TIME (see "System
Information).
20 °C
5...30 °C
This key sets the reduced room temperature setpoint in
the automatic program between the heating cycles as
well as during the ABSENT and REDUCED operating
modes. In this operating mode, the setpoint is identical
for all the heating circuits.
11
SDC / DHC 43
EN2H-0220 GE51 R1005