Table of Contents
Advertisement
Using the Auto-Adjustment feature (VGA analog input)
When first setting up the monitor, when conducting a Factory Reset of the computer, or whenever you
change the resolution of the monitor, the Auto-Adjustment feature will automatically engage, and
attempt to optimize your screen for you.
You may also optimize the screen performance for the VGA (analog) input at any time by using the +
(Plus) button on the right side of the monitor.
Do not use this procedure if the monitor is using an input other than VGA. If the monitor is using a
VGA (analog) input, this procedure can correct the following image quality conditions:
Fuzzy or unclear focus
●
Ghosting, streaking or shadowing effects
●
Faint vertical bars
●
Thin, horizontal scrolling lines
●
An off-center picture
●
To use the Auto-Adjustment feature:
1.
Allow the monitor to warm up for 20 minutes before adjusting.
2.
Press one of the three buttons on the right side of the monitor to activate the buttons.
3.
Press the Auto-Adjust button on the right side of the monitor.
You can also press the Menu button, and then select Image Control > Auto-Adjustment
●
from the OSD.
If the result is not satisfactory, continue with the procedure.
●
4.
Insert the disc included with the monitor into the disc drive. The disc menu is displayed.
5.
Select Open Auto-Adjustment Software. The setup test pattern is displayed.
6.
Press one of the three buttons on the right side of the monitor to activate the buttons.
7.
Press the Auto-Adjust button on the right side of the monitor to produce a stable, centered
image.
8.
Press the
NOTE:
The auto-adjustment test pattern utility can be downloaded from http://www.hp.com/support.
ESC
key or any other key on the keyboard to exit the test pattern.
Using the Auto-Adjustment feature (VGA analog input)
27
Advertisement
Table of Contents
