Table of Contents
Advertisement
Adjusting the tilt
Tilt the monitor panel forward or backward to set it to a comfortable eye level.
Mounting the monitor (select models)
A VESA mounting bracket is available for select models only. The mounting bracket can be used to
attach the monitor to any standard mounting system with a standard VESA 100mm x 100mm mount
pattern.
NOTE:
This apparatus is intended to be supported by UL or CSA Listed wall mount bracket.
CAUTION:
third-party mounting solution to the monitor, four 4 mm, 0.7 pitch, and 10 mm long screws are
required. It is important to verify that the manufacturer's mounting solution is compliant with the VESA
standard and is rated to support the weight of the monitor display panel. For best performance, it is
important to use the power and video cables provided with the monitor.
Removing the monitor stand
You can remove the monitor panel from the stand to install the panel on a wall, a swing arm, or other
mounting fixture.
CAUTION:
cables are disconnected.
1.
Disconnect and remove all cables from the monitor.
2.
Lay the monitor
CAUTION:
of the display panel may damage the panel if the monitor is placed face down.
This monitor supports the VESA industry standard 100 mm mounting holes. To attach a
Before beginning to disassemble the monitor, be sure the monitor is turned off and all
face up on a flat surface covered by a clean, dry cloth.
Do not lay the monitor face down when installing the stand. Stress on the curvature
Adjusting the tilt
11
Advertisement
Table of Contents
