Stop The Engine - Craftsman C950-52124-0 Owner's Manual

OPERATION
7. Electric Start: First connect the extension cord to the power
cord receptacle and then into a wall receptacle. If additional ex-
tension cord is required, make sure it is three-wire.
WARNING: If the extension cord is damaged, it
must be replaced by the manufacturer (or its
service agent) or a similarly qualified person to
avoid a hazard.
8.
Electric Start: Depress the starter push button (A, Figure 9).
After you start the engine, first disconnect the extension cord from
the wall receptacle and then from the power cord receptacle (B).
IMPORTANT: To extend the life of the starter, use short
starting cycles (five seconds maximum). Wait one minute
between starting cycles.
NOTE: If the engine does not start after three attempts, see an
authorized dealer.

STOP THE ENGINE

Before stopping the engine for a few minutes to help dry off any
moisture on the engine.
1. Remove the safety key (A, Figure 7).
2. Keep the safety key out of the reach of children.
NOTE: Do not lose the safety key. Keep the safety key in a safe
place. The engine will not start without the safety/ignition key.
A
B
Figure 9
16
WARNING: Gasoline and vapors are extremely
flammable and explosive. Fire or explosion can
cause severe burns or death. DO NOT choke the
carburetor to stop the engine.