Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Ubiquiti Rocket M2 Titanium RM2-Ti
Summary of Contents for Ubiquiti Rocket M2 Titanium RM2-Ti
- Page 1 Carrier Class airMAX BaseStation ™ Models: RM2-Ti, RM5-Ti...
-
Page 2: Package Contents
Ethernet cable from Ubiquiti Networks. For more details, visit www.ubnt.com/toughcable TERMS OF USE: Ubiquiti radio devices must be professionally installed. Shielded Ethernet cable and earth grounding must be used as conditions of product warranty. TOUGHCable is designed for outdoor installations. It is the customer’s responsibility to follow local country regulations, including operation within legal frequency channels, output power, and Dynamic Frequency Selection (DFS) requirements. -
Page 3: Hardware Overview
Hardware Overview RP-SMA Connections to Antenna LED Panel Port Cover Reset GPS SMA Connector Button (RM5-Ti only) Main Ethernet Port Secondary Ethernet Port (10/100/1000 Mbps) (10/100 Mbps) - Page 4 LED Panel Signal In airOS, you can modify the wireless signal strength threshold values for each LED on the Advanced tab under Signal LED Thresholds, or you can configure the LEDs to display the GPS connection quality instead (RM5-Ti only). The default values are shown below: LED will light green when the wireless signal strength is above -65 dBm.
-
Page 5: Hardware Installation
Hardware Installation The RocketM Titanium is designed to mount directly onto Ubiquiti airMAX RocketDish or Titanium Sector antennas. ™ ™ It can also be mounted directly on a pole. 1. Press the release buttons on the sides of the Port Cover and slide it off. - Page 6 2. Connect an Ethernet cable to the Main Ethernet port. 3. (RM5-Ti only) Connect the GPS Patch Antenna to the GPS SMA Connector. 4. Replace the Port Cover.
- Page 7 5. Connect the RF cables to the RP-SMA Connectors located on top of the RocketM Titanium. 6. Attach the RocketM Titanium to an antenna. Align the mounting tabs on the back of the RocketM Titanium with the mounting bracket on the antenna. Slide the RocketM Titanium down until it locks into place.
- Page 8 7. Attach the RF cables from the RocketM Titanium to the connectors on the antenna. Connecting to a Dish Antenna Connecting to a Sector Antenna 8. Attach the Protective Shroud. a. Align the arrow on the a. Slide the shroud down top of the shroud with over the Rocket until it the short hash mark on...
-
Page 9: Pole Mounting
9. (RM5-Ti only) Place the magnetic GPS Patch Antenna on the upper pole-mounting bracket. Placement on a Dish Antenna Placement on a Sector Antenna Pole-Mounting To mount the RocketM Titanium on a pole, use the included Metal Strap and perform the following steps: 1. - Page 10 2. Straighten out the end of the Metal Strap and slide it through the back of the RocketM Titanium. 3. Wrap the Metal Strap around the pole. To tighten the strap, turn the screw clockwise using a flathead screwdriver.
-
Page 11: Connecting Power Over Ethernet
Connecting Power over Ethernet 1. Connect the other end of the Ethernet cable from the RocketM Titanium to the Ethernet port labeled POE on the PoE Adapter. 2. Connect an Ethernet cable from your LAN to the Ethernet port labeled LAN on the PoE Adapter. 3. - Page 12 Accessing airOS Connect to the airOS Configuration Interface. 1. Make sure that your host machine is connected via Ethernet to the RocketM Titanium. 2. Configure the Ethernet adapter on your host system with a static IP address on the 192.168.1.x subnet. 3.
- Page 13 5. (RM5-Ti only) On the Main tab you can verify the GPS Signal Quality. Click the GPS Details link under Monitor to view the Satellite and Signal details. GPS Details link airSync Capabilities (RM5-Ti only) airSync resolves co-location interference issues. Many situations require the use of multiple airMAX M series devices on the same tower.
- Page 14 This resolves the interference issues. Enabling Master/Slave Mode 1. Launch your web browser and log in to the airOS Configuration Interface. 2. Click the Ubiquiti tab. 3. Select the appropriate mode: • Master Mode (synchronization master device) • Slave Mode (slave devices)
-
Page 15: Installer Compliance Responsibility
Since Ubiquiti Networks equipment can be paired with a variety of antennas and cables, the Antenna Gain, Cable Loss, and Output Power fields are provided to the professional... -
Page 16: Specifications
Specifications RocketM Titanium Dimensions 160 x 80 x 44 mm Weight 350 g Operating Frequency RM2-Ti 2412 - 2462 MHz RM5-Ti 5170 - 5875 MHz* Networking Interface (1) 10/100/1000 Ethernet Port (Main) (1) 10/100 Ethernet Port (Secondary) RF Connectors 2 RP-SMA (Waterproof ) RM2-Ti 2 RP-SMA (Waterproof ), 1 SMA (GPS) RM5-Ti... -
Page 17: Safety Notices
Safety Notices Read, follow, and keep these instructions. Heed all warnings. Only use attachments/accessories specified by the manufacturer. WARNING: Do not use this product in location that can be submerged by water. WARNING: Avoid using this product during an electrical storm. -
Page 18: Limited Warranty
Ubiquiti MAC label, or is missing any other original Ubiquiti label(s); or (VII) has not been received by Ubiquiti within 30 days of issuance of the RMA. In addition, the above warranty shall apply only if: the product has been properly installed and used at all times in accordance, and in all material respects, with the applicable Product documentation;... - Page 19 No Products will be accepted for replacement or repair without obtaining a Return Materials Authorization (RMA) number from UBIQUITI NETWORKS during the warranty period, and the Products being received at UBIQUITI NETWORKS’ facility freight prepaid in accordance with the RMA process of UBIQUITI NETWORKS.
-
Page 20: Limitation Of Liability
Limitation of Liability EXCEPT TO THE EXTENT PROHIBITED BY LOCAL LAW, IN NO EVENT WILL UBIQUITI OR ITS SUBSIDIARIES, AFFILIATES OR SUPPLIERS BE LIABLE FOR DIRECT, SPECIAL, INCIDENTAL, CONSEQUENTIAL OR OTHER DAMAGES (INCLUDING LOST PROFIT, LOST DATA, OR DOWNTIME COSTS), ARISING... - Page 21 Compliance Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation.
-
Page 22: Industry Canada
Industry Canada This Class A digital apparatus complies with Canadian ICES-003. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for successful communication. -
Page 23: Rf Exposure Warning
RF Exposure Warning The antennas used for this transmitter must be installed to provide a separation distance of at least 243 cm from all persons and must not be located or operating in conjunction with any other antenna or transmitter. Les antennes utilisées pour ce transmetteur doivent être installé... - Page 24 RoHS/WEEE Compliance Statement English European Directive 2002/96/EC requires that the equipment bearing this symbol on the product and/or its packaging must not be disposed of with unsorted municipal waste. The symbol indicates that this product should be disposed of separately from regular household waste streams.
- Page 25 Español La Directiva 2002/96/CE de la UE exige que los equipos que lleven este símbolo en el propio aparato y/o en su embalaje no deben eliminarse junto con otros residuos urbanos no seleccionados. El símbolo indica que el producto en cuestión debe separarse de los residuos domésticos convencionales con vistas a su eliminación.
-
Page 26: Declaration Of Conformity
UBIQUITI NETWORKS device, megfelel a vonatkozó alapvetõ [Hungarian] követelményeknek és az 1999/5/EC irányelv egyéb elõírásainak. Íslenska Hér me l sir UBIQUITI NETWORKS yfir ví a UBIQUITI NETWORKS device, er í samræmi vi grunnkröfur og a rar kröfur, sem ger ar eru í [Icelandic] tilskipun 1999/5/EC. -
Page 27: Online Resources
Latviski Ar o UBIQUITI NETWORKS deklar , ka UBIQUITI NETWORKS device, atbilst Direkt vas 1999/5/EK b tiskaj m pras b m un citiem ar to saist [Latvian] tajiem noteikumiem. Lietuviškai UBIQUITI NETWORKS deklaruoja, kad šis UBIQUITI NETWORKS įrenginys atitinka esminius reikalavimus ir kitas 1999/5/EB [Lithuanian] Direktyvos nuostatas. - Page 28 . u b n t . c o m © 2011-2013 Ubiquiti Networks, Inc. All rights reserved. J053113—720-00039-01...