Panasonic WH-MXF09D3E8 Service Manual page 70

5. Reset overload protector
Overload Protector serves the safety purpose to prevent the water over heating. When the Overload
Protector a trip at high water temperature, take below steps to reset it.
Take out OLP Cover.
o
Use a test pen to push the centre button gently in order to reset the Overload protector.
o
Fix the OLP Cover to the original fixing condition.
o
6. External water filter (field supply)
Clean the external water filter in regularly basic.
External water filter is located inside the tube connector which is before water inlet connector of Mono
bloc unit (indicated with "WATER IN"). (Refer to figure below)
Use spanner to detach the tube connector nut.
Take out the filter carefully so that not deforms it shape.
Use tap water only to wash the residue on the filter. If necessary, gently use soft brush only to clean the
hard dirt.
After clean, put it back to the original location and tighten the nut connection with torque wrench.
Water Inlet Nut
Connector
Location Of External Water Filter
70
Water Outlet
External
Water Filter
Water Inlet