Erasing Programs (Erase); Entering And Editing Program Titles (Enter Title); Checking Program Contents (Properties); Protecting Programs/Releasing Program Protection (Protection) - Panasonic LQ-MD800P Operating Instructions Manual

Using the SEARCH PROGRAM (continued)

Erasing programs (Erase)

RAM DVD-R
The program is erased completely when you use this
procedure and cannot be retrieved. Check the program
carefully before erasing it to ensure it isn't one you want
to keep.
(1) Press [SEARCH].
(2) Use [ ,
program.
(3) Use [ ] so the submenu appears.
(4) Use [ ,
press [ENTER].
(5) Use [ ] to select "Erase".
(6) Press [ENTER].
To stop partway through
Select "Cancel" in step (5) and press [ENTER] or [RETURN].
For your reference:
• The disc's available recording time may not increase after
erasing short programs.
• Computer data is not erased.
• The available recording time on DVD-R does not increase when
you erase programs.
Entering and editing program titles
(Enter Title)
RAM DVD-R
After performing steps (1) to (3) of "Erasing
programs", perform the following steps:
(4) Use [ ,
[ENTER].
(5) Enter or edit the title.
(see page 32)
For your reference:
• You can give DVD-RAM titles of up to 64 characters
• The 33rd letter or later on some finalized DVD-R may not be
displayed due to the font size of titles.
• You can give DVD-R titles of up to 44 characters.
• The full title is shown in the "Properties" screen, but if you enter
a long title, only part of it is shown in the program list.
Downloaded From Disc-Player.com Panasonic Manuals
] to select the desired
] to select "Erase" and
] to select "Enter Title" and press

Checking program contents (Properties)

RAM DVD-R
You can check the contents of a selected program.
After performing steps (1) to (3) of "Erasing
programs", perform the following steps:
(4) Use [ , ] to select "Properties" and press
[ENTER].
• The contents of the program are shown.
To return to the previous screen
Press [RETURN].
Protecting programs/Releasing
program protection (Protection)
RAM
You can prevent accidental erasure of programs by write-protecting
them.
After performing steps (1) to (3) of "Erasing
programs", perform the following steps:
(4) Use [ , ] to select "Protection" and press
[ENTER].
(5) Use [ ] to select "Yes" and press [ENTER].
The padlock mark appears.
To stop partway through
Select "No" in step 5 and press [ENTER] or [RETURN].
For your reference:
• Programs will be erased even if they are protected if you format
the disc with DISC INFORMATION.
– 26 –
The padlock mark disappears.