Instructions For Use; Check The Package Contents; Setting Up The Parent Unit - LeapFrog Advanced Baby Monitor Instruction Manual

Instructions for use

Check the package
contents
The package contains:
• 1 Parent unit (receiver) with
belt clip
• 1 charger pod with fi xed
mains adaptor
• 2 x 800mAh NiMH
rechargeable batteries
• 1 Baby unit (sender)
• 1 mains adaptor
• 1 travel bag
• 1 instruction manual
Setting up
At the parent unit
1. Remove the battery cover on
the back of the parent unit with a
crosshead screwdriver.
Torch
2. Insert the 2 x AAA 1.2V
800mAh Nickel Metal Hydride
rechargeable batteries provided,
taking care to note the '+' and
'-' markings and position the
batteries the correct way around.
Replace the battery cover and
re-tighten the screw.
Leapfrog Advanced BM.indd 5 Leapfrog Advanced BM.indd 5
3. Fit the belt clip by sliding into
place until it clicks home.
Torch
4. Plug the charger pod mains
adaptor into a mains power
socket and switch on.
5. Place the parent unit in the
charger pod and charge for a
minimum of 13 hours before fi rst
use or if it has not been used for a
long time.
The red LED on the charger pod
will light up to confi rm that the
parent unit is charging and will
remain on whilst the parent unit is
in the charger pod.
Note: The parent unit cannot
be used without rechargeable
batteries, even if it is placed in the
charger.
6. Press and release the 'Power'
key on the side of the parent unit
to switch it on.
5
26/6/08 09:10:29 26/6/08 09:10:29