Seat Belts And Tether Belts; Seat Belt Inspection; Seat Belt Operation - freightliner BUSINESS CLASS M2 Driver Manual

Cab Features

Seat Belts and Tether Belts

General Information
Seat belt assemblies are designed to secure persons
in the vehicle to help reduce the chance of injury or
the amount of injury resulting from accidents or sud-
den stops. For this reason, Daimler Trucks North
America LLC urges that the driver and all passen-
gers, regardless of age or physical condition, use
seat belts when riding in the vehicle.
WARNING
Always use the vehicle's seat belt system when
operating the vehicle. Failure to do so can result
in severe personal injury or death.
Seat belt assemblies in Daimler Trucks North
America (DTNA) vehicles meet Federal Motor Ve-
hicle Safety Standard 209, "Type 1" and "Type 2" re-
quirements.
When transporting a child, always use a child re-
straint system or the vehicle seat belts as appropri-
ate. To determine whether a child restraint system is
required, review and comply with applicable state
and local laws. Any child restraint used must comply
with Federal Motor Vehicle Safety Standard 213,
"Child Restraint Systems." When providing a child
restraint system, always carefully read and follow all
instructions pertaining to installation and usage for
the child. Make certain the child remains in the re-
straint system at all times when the vehicle is in mo-
tion.
In addition to seat belt assemblies, tether belts are
installed on suspension-type seats. Tether belts help
secure the seat to the floor and are intended to re-
strain the seat and seat belt in case of an accident or
sudden stop.
IMPORTANT: Seat belts have a finite life which
may be much shorter than the life of the vehicle.
Regular inspections and replacement as needed
are the only assurance of adequate seat belt
security over the life of the vehicle.
5.7

Seat Belt Inspection

WARNING
Inspect and maintain seat belts. When any part of
a seat belt system needs replacement, the entire
seat belt must be replaced, both retractor and
buckle side. Any time a vehicle is involved in an
accident, and the seat belt system was in use,
the entire vehicle seat belt system must be re-
placed before operating the vehicle. Do not at-
tempt to modify the seat belt system; doing so
could change the effectiveness of the system.
Failure to replace worn or damaged seat belts, or
making any modifications to the system, may re-
sult in personal injury or death.
Inspect the seat belts and tether belts (if so
equipped).
1.
Check the web for fraying, cuts, extreme dirt and
dust, or for severe fading from exposure to sun-
light, especially near the buckle latch plate and in
the D-loop guide area.
2.
Check operation of the buckle, latch, Komfort
Latch or Sliding Komfort Latch (if equipped), web
retractor, and upper seat belt mount on the door
pillar. Check all visible components for wear or
damage.
3.
Check the seat belt and tether belt connection
points and tighten any that are loose.

Seat Belt Operation

Three-Point Seat Belt With Komfort Latch
or Sliding Komfort Latch
WARNING
Wear three-point seat belts only as described
below. Three-point seat belts are designed to be
worn by one person at a time. In case of an acci-
dent or sudden stop, personal injury or death
could result from misuse.
Fasten the seat belts before driving. Fastening a
three-point seat belt while driving creates a haz-
ard.
When engaged and used properly, the Komfort Latch
(Fig. 5.16) and the Sliding Komfort Latch (Fig. 5.17)