10.1 Ripping/Through Sawing
10.0 Cutting
Have riving knife and blade guard in
place - danger of injury.
10.2 Through Cross/Mitre Cuts
A - Have riving knife and blade guard
in place - danger of injury.
D - Push mitre and work forward to
feed into blade
Set blade guard to thickness of work-
piece.
Important!
-
Have blade at complete standstill before making adjustments - Disconnect
machine from power before setting riving knife
-
If width of cut is less than 120mm-41/2" always use a push stick to feed the
work
B - Swing mitre fence onto table and
set to required angle
E - When cut is completed pull back
both mitre fence and work
Set rip fence to desired width of cut
and lock in position.
C - Pull mitre fence back and place
work against it.
- Start machine