Side Cover L Assy - Brother HL-4040CN, HL-4050CDN, HL-4070CDW Service Manual

8.17 Side Cover L ASSY

(1) Remove the cup S M3x8 Taptite screw and three cup B M4x12 Taptite screws.
(2) Release the three Hooks on the bottom and the two hooks on the back side, and then
remove the Side cover L ASSY.
Note:
When removing the Side cover L ASSY, pay attention to the Wire support rope.
Taptite, cup B M4x12
(Tightening torque:
1.20 ±0.1 N m)
*1
Hooks
Side cover L ASSY
Taptite, cup S M3x8
*1
Tightening Note:
When tightening the screw, slowly turn it counterclockwise (in the direction to loosen the
screw) with your hand until you feel that the screw is a little dropped in the hole. Then,
slightly turn it clockwise (in the direction to tighten the screw) with your hand and tighten
it according to the specified torque with a screwdriver.
(3) Remove the Access cover from the Side cover L.
Hook
Hooks
Side cover L
<Left side>
3b
Access cover
<Left side>
Taptite, cup B M4x12
(Tightening torque: 1.20 ±0.1 N m)
Fig. 3-54
3a
Fig. 3-55
3-51
Wire support rope
*1
Confidential