Security; Change Supervisor Password - Pegatron IPMTB-GS Reference Manual

8 BIOS Setup reference

Security

The security items allow you to view or change system security settings.
Advanced
Main
Security Settings
Supervisor Password
User Password

Change Supervisor Password

Change User Password
v02.61
Change Supervisor Password
Select this item to set or change the supervisor password. The Supervisor
Password item on top of the screen shows the default Not Installed. After you set
a password, this item shows Installed.
To set a Supervisor Password:
1. Select the Change Supervisor
Password item and press <Enter>.
2. From the password box, type a
password composed of at least six
letters and/or numbers, then press
<Enter>.
3. Confirm the password when
prompted.
The message "Password Installed" appears after you successfully set your
password. To change the supervisor password, follow the same steps as in setting
a user password. To clear the supervisor password, select the Change Supervisor
Password then press <Enter>. The message "Password Uninstalled" appears.
NOTE: If you forget your BIOS password, you can clear it by erasing the CMOS
Real Time Clock (RTC) RAM. See your hardware documentation for information
on how to erase the RTC RAM.
26
BIOS SETUP UTILITY
Power Security
:Not Installed
:Not Installed
(C) Copyright 1985-2008, American Megatrends, Inc.
Exit
Boot
Install or Change the
password.
Enter
F1
F10
ESC
Enter New Password
IPMTB-GS Motherboard Reference Guide
Select Screen
Select Item
Change
General Help
Save and Exit
Exit