WHAT YOU HAVE Please checkout following parts after opening the box QUANTITY QUANTITY PARTS PARTS 10A. TRANSMITTER HOLDER 1. 8” DOWNROD WITH WITH 2 MOUNTING RUBBER WHEEL SCREWS 2. CANOPY 11. RECEIVER 3. COUPLING COVER 4. FAN HOUSING & MOTOR SCREW PACKAGE QUANTITY 5.
Page 3
WARNING A). TO ENSURE YOUR PERSONAL SAFETY, PLEASE READ THROUGH THE INSTRUCTION MANUAL BEFORE USE 1) Do not bend the blade brackets during the brackets installation, blades balancing or fan cleaning. 2) To prevent accidents, power switch must be OFF before ceiling fan installation. 3) Ceiling fan installation and electrical wiring must be done by qualified technician in accordance with all applicable codes and air conditioning engineers (ASHRAE) or the local qualified authorities.
INSTALLATION PROCEDURES Before ceiling fan installation, please go through the procedures in detail with the picture diagrams as reference. DIAGRAM 1 STEP 1 (See Diagram 1) 1 ) Loosen 2 screws on the motor coupling. 2 ) Insert the downrod through top canopy Downrod and coupling cover.
STEP 3 (See Diagram 3) Connect the Motor Wiring to Receiver first! Connect wiring as below:- FROM Orange Wire Terminal Block (marked“ ”) Receiver (FOR LIGHT) Brown Wire Terminal Block (marked “ L ” Receiver (TO MOTOR L) Blue Wire Receiver Terminal Block (marked “...
Page 6
DIAGRAM 5 STEP 5 (See Diagram 5) 1) Screw the blade holder onto the Blade Holder fan blade and decorative cover. Fan Blade 2) Repeat the same step on all the remaining fan blades. STEP 6 (See Diagram 6) 1) Remove all the screws on the plastic ring, the screws are used to Decorative Cover install the blade holders to the...
Page 7
Please request installer to do balancing, in the event of ceiling fan wobbles after installation. Please refer to balancing procedure included in the balancing kit provided. WARNING! FA S T E N T H E S A F E T Y C A B L E T O T H E M O U N T E D EXPANSION J HOOK FOR SAFETY PURPOSES.
Need help?
Do you have a question about the RCF-PA200-5BL and is the answer not in the manual?
Questions and answers
Should the **** rotate clockwise or anticlockwise?