Elation Design LED 108IP User Instructions page 19

1, the second unit to 4 (3 + 1), the third unit to 7 (3 + 4), and so on.
Note: During start-up the Design LED 108IP ™ will automatically detect whether a DMX
data signal is being received or not. If a DMX data signal is being received, the display will
show "A.XXX" (XXX representing the actual DMX address). If the fixture is not receiving a
DMX signal the display will flash "A.XXX" (XXX representing the actual DMX address).
If your fixture is connected to a DMX controller and the display is flashing (not receiving a
DMX signal), please check the following:
- The 3-pin or 5-pin XLR plug (cable with DMX signal from controller) may not be
connected or is not inserted completely into the DMX input jack.
The DMX controller is switched off or defective.
-
The DMX cable or connector is defective.
-
A DMX terminator has been inserted into the last fixture in your DMX chain.
-
©Elation Professional, Los Angeles Ca. 18
DESIGN LED 108IP™
www.ElationLighting.com