Selecting A Source - Meridian DSP Loudspeaker User Manual

28
Using the DSP

Selecting a source

loudspeakers
When not playing, the DSP loudspeakers should be
left in the standby state. This uses a negligible amount
of electricity, but ensures that the components of the
loudspeakers operate at maximum efficiency from the
moment you start.
If you are not going to use the DSP loudspeakers for
several days you should switch each unit completely off
at the back panel, and disconnect it from the AC power
supply.
To select a source
• Press the appropriate source key on the remote; eg
Radio.
This will bring the DSP loudspeakers out of standby,
and the displays will show the currently selected source
and volume setting.
For example:
Initially all the sources are set to use the SpeakerLink
digital input. To configure all sources to use the co-axial
input, configure the speaker as M.Coax or S.Coax;
see To choose master or slave and the primary
connector , page 34. To configure an individual source
to use a different input see To configure a source ,
page 37.
To switch to standby
• Press Off on the remote.
The displays will show:
Radio 65
.