Selecting A Source - Meridian DSP5000 User Manual

USING THE DSP
LOUDSPEAKERS

Selecting a source

When not playing, the DSP loudspeakers should be left in the standby
state. This uses a negligible amount of electricity, but ensures that the
components of the loudspeakers operate at maximum efficiency from the
moment you start.
If you are not going to use the DSP loudspeakers for several days you
should switch each unit completely off at the back panel, and disconnect it
from the AC power supply.
To select a source
• Press the appropriate source key on the remote; eg Radio.
This will bring the DSP loudspeakers out of standby, and the displays will
show the currently selected source and volume setting.
Radio 65
For example:
By default the 12 sources are available.
As standard, all the sources are set to select the D1 digital input. To select
the D2 input, see To configure a source, page 33.
To switch to standby
• Press Off on the remote.
The loudspeakers will switch to standby
.
and the displays will show:
24