Troubleshooting - SodaStream Source Instruction Manual

You might be out of gas; replace your carbonator.
Check that carbonating bottle has been filled up with water to the fill line.
Ensure that the Soda Maker is always in the upright position.
Carbonator may be loose. DO NOT use tools. Detach the bottle, open the rear cover,
and retighten the carbonator. Apply firm pressure but do not over tighten. If the
carbonator is already firmly in place, it may be empty. Replace with a full carbonator.
WARNING: Use caution when removing carbonator as it may be very cold.
CANNOT PULL BOTTLE LOADER TAB:
Make sure carbonating block is in its fully upward position.
Pull bottle loader tab firmly towards you.
CANNOT INSERT THE BOTTLE INTO THE SNAP-LOCK:
Make sure the carbonating block is in its fully upward position.
Pull the bottle loader tab toward you until it clicks.
Insert bottle into Snap-Lock.
Firmly push bottle up and back until it locks.
CANNOT GET THE BOTTLE OUT:
Make sure the carbonating block is in its fully upward position.
Pull the bottle toward you.