Assemble The Main Shaft To The Table Bed - Teeter Hang Ups EP-960 Assembly Instructions Manual

STEP 6
FIGURE 21
FIGURE 21a
FIGURE 22
FIGURE 23

Assemble the Main Shaft to the Table Bed

• Facing the front of the A-Frame, hold the Main Shaft in your left hand with the height
markings facing up. Slide the end of the Main Shaft into the Main Shaft Housing (Figure
21), located at the base of the Table Bed.
• With your right hand, pull out the Height-Selector Locking Pin (Figure 21a) to allow the
Main Shaft to slide in further and release in the desired height setting. Refer to the Owner's
Manual for more information on selecting your height setting.
• The Main Shaft MUST REST against the Crossbar of the A-Frame (Figure 22).
IMPORTANT: The Crossbar prevents the Table Bed from rotating forward when the user
steps on the Ankle Comfort Dial. If the Main Shaft does not rest on the Crossbar as shown
in Figure 22, then the Table Bed has been assembled backwards onto the A-Frame.
This MUST BE CORRECTED before use.
• Test the inversion table by hand for smooth and steady rotation (Figure 23) and ensure that
all fasteners are secure.
14