Stretch Max Handle Assembly - Lower Portion; Assemble The Lower Handle Portion - Teeter Hang Ups EP-960 Assembly Instructions Manual

STEP 2 Stretch Max Handle Assembly - Lower Portion
FIGURE 5
1
2
3
1 2 3
Spreader Arm Stretch Max Handle
FIGURE 6
Locked

Assemble the Lower Handle Portion

NOTE: The lower handle portion will be positioned between the A-Frame and Spreader Arm.
• Insert the Bolt into the A-frame from the inside (Figure 5) and assemble two Washers onto
the Bolt on the outside of the A-frame.
• Position the lower handle portion over the Bolt, then place another Washer onto the Bolt.
• Position the unassembled end of the Spreader Arm onto the Bolt, then secure the assembly
with the Nut. Confirm that the parts are assembled in this order:
Bolt > A-Frame > Washer > Washer > Handle > Washer > Spreader Arm > Nut (Figure 5)
• Fully tighten all fasteners, being careful not to overtighten.
• Upper Portion: Fully tighten the Allen Head Screws (assembled in Step 1) using the
5mm Allen Wrench provided.
• Lower Portion: Fully tighten the Nut onto the Bolt using the 10/13 wrenches provided.
• Carefully rotate the A-Frame so that it is standing upright and the Stability Feet are on the
ground. Gently push down on the assembled Spreader Arm to ensure it is fully open and in
A-Frame
the "locked" position (Figure 6).
• In this upright position, repeat the assembly steps for the upper and lower handle portion on
the unassembled side.
• Figure 7 on the next page shows the Stretch Max Handles and A-Frame fully assembled.
9