Wavion WBS-2400 Installation Manual page 31

W
bonded to the unit and to the protective earth (PE) at the building
entrance. This provides protection against the risk of fire, electrical hazard
and ensures the reliable operation of this equipment.
Note:
an Agency Listed (UL/CSA) Building Entrance Protector for all power
and communications cables entering a building. Article 800 is intended
to protect the building and occupants from fires caused by transient
voltage and current surges.
Note:
chain Power Over Ethernet devices.
When connecting to the Ethernet port, if you need to terminate the Ethernet cable, use a
standard RJ45 termination. Use a shielded RJ45 plug and be sure to connect the shield of
the Ethernet cable to the shield of the RJ 45 plug.
To connect to the data port:
1. Make sure that the power is turned off for the designated circuits.
2. Run shielded Category 5 Ethernet cable appropriates for outdoor use from a POE
injector to the Wavion WBS-2400/5800/5000P through the lightning protection
device. See "Grounding the Data protection device" section for connection
diagram.
3. Connect one end of the Category 5 cable to the "RADIO" port of the Wavion POE
injector.
4. Unscrew the plastic cap and the cap cover from the Wavion WBS-
2400/5800/5000P.
5. Thread the Ethernet cable through the cap cover and the cap.
6. Connect the other cable end to ETH port on the WBS-2400/5800/5000P. Use a
shielded RJ45 8-pin modular plug to terminate the cables at the desired lengths
7. After connecting the Ethernet cable to the "ETH" port screw the plastic cap, make
sure it is well tighten.
8. Screw the cap cover to ensure perfect sealing. It will ensure IP-67 compliance.
9. "Test" port: The test port must be sealed with the provided plastic cap., make
sure it is attached properly.
ARNING: The shields of the Cat5 cable must be properly terminated and
National Electrical Codes (NEC) Article 800 requires the use of
This is not a mid-span powered device. Do not attempt to daisy-
Installation Guide 31