Wavion WBS-2400 Installation Manual page 23

Sealing Technique:
1. After the antenna is connected, use the supplied isolation tape to cover the
N-Type connectors and the lower part of the antennas, to a height of a
shrink tube.
2. Cut 18 cm of the attached Scotch 23 splicing tape and remove thin plastic
cover to expose the tacky side of the sealing tape.
3. Apply the tape with tacky side up on the antenna and N-Type connector.
Stretch tape and apply 1/2-lapped to form smooth, void-free splice
Caution
: It is important to read carefully this procedure and perform all
its steps to ensure maximal moisture protection.
Caution
: It is important to read carefully this procedure and perform all
its steps to ensure maximal moisture protection.
Installation Guide 23