Advertisement
Setting Oven
Controls
To set the controls
for a cleaning
cycle:
It is recommended
to use a 2 hour clean cycle for light soils, a 3
hour cycle for average
soils, and a 4 hour cycle
for heavy soils.
1.
Turn both the oven mode and oven temperature
selectors to
CLEAN.
The display
will show a 3 hour time (normal
clean).
2.
Use
theA
and
V
keys to select a 2 or 4 hour time if
desired.
3.
Once the control
accepts
a clean time, the REMOVE
RACKS
message
will blink in the display.
If the door
is open the
CLOSE DOOR
message
will also appear.
If the user does
not shut the door within
3 minutes
of the display
showing
the door open message,
the control
will cancel
the Clean
function.
4.
After the REMOVE
RACKS message
ends the oven door will
begin
locking.
Do not attempt
to open the door while the
motor door
latch mechanism
is locking
or when any locking
indicators
or displays
are showing.
The oven door should
be
completely
locked
in about
15 seconds.
5.
CLn and the lock icon will appear
in the display
when the
door is fully
locked.
The oven will start the Clean function.
6.
The time left in the clean will be displayed
under the CLn
message.
When the Clean
time ends:
1.
CLn will change
to Hot in the display
and the lock icon will
remain
visible.
The oven door remains
locked
until the oven
has cooled
to a safe temperature
2.
When
the temperature
drops
to the safe level, the display
will fade
out Hot from the timer display.
The motor door
lock unlocks automatically.
Do not attempt
to open the oven
door until the lock icon disappears
from
the display.
The
oven door should
completely
unlock
in about
15 seconds.
3.
The display
will then fade
in ---
(dashes)
to prompt
user to
rotate
both the oven mode and temperature
selector
knobs
to the OFF position.
Important
note:
Do not force
the oven door open when the self-
clean is active.
This can damage
the automatic
door
locking
system. The oven may still be very hot, be sure to stand to the
side of the oven door when opening
after
a clean cycle to allow
any heat or steam to escape.
If Clean is active
and a power
failure
occurs, the oven may not
have thoroughly
cleaned.
This would
depend
on how much
cleaning
time had elapsed
before
the power
failure.
If needed
after
power
is restored,
set Clean again.
22
Advertisement
