Homelink Universal Transceiver With Travelnote; Compass Calibration Adjustment - Mercury 1999 Mountaineer Owner's Manual

Controls and features

Compass calibration adjustment

Perform this adjustment in an open
area free from steel structures and
high voltage lines:
Press and hold the MODE control
until CAL appears in the display
(approximately eight seconds)
and release.
Drive the vehicle slowly (less
than 5 km/h [3 mph]) in circles
until CAL indicator turns off in
about 2–3 complete circles.

HOMELINK UNIVERSAL TRANSCEIVER WITH TRAVELNOTE

(IF EQUIPPED)
The HomeLink Universal Transceiver, located on the driver's visor,
provides a convenient way to replace up to three hand-held transmitters
with a single built-in device. This feature will learn the radio frequency
codes of most current transmitters to operate garage doors, entry gates,
security systems, entry door locks, and home or office lighting.
When programming your HomeLink Universal Transceiver, to a
garage door or gate be sure that people and objects are out of
the way to prevent potential harm or damage.
Do not use the HomeLink Universal Transceiver with any garage door
opener that lacks safety stop and reverse features as required by U.S.
federal safety standards (this includes any garage door opener model
manufactured before April 1, 1982). A garage door which cannot detect
an object, signaling the door to stop and reverse, does not meet current
U.S. federal safety standards. For more information on this matter, call
toll-free: 1–800–355–3515 or on the Internet at HomeLink.jci.com.
92