Center Armrest/Rear Cupholder; Positive Retention Floor Mat; Rear Liftgate - Mercury 1999 Mountaineer Owner's Manual

CENTER ARMREST/REAR CUPHOLDER

Do not attempt to raise the console
armrest when the rear cupholder is
in use. If you find resistance when
raising the armrest, make sure the
cupholder is fully closed or else
damage may occur to the armrest.

POSITIVE RETENTION FLOOR MAT

To install floor mats:
1. Move the driver's seat to the most rearward position
2. Position the driver's side floor mat with the rear of the mat against left
(outboard) front edge of seat track mounting bracket.
3. Use a screwdriver to screw locator post into vehicle carpeting. Exert
pressure while turning to pierce the carpeting.
When installed properly, the locator will not screw down tightly, but will
rotate freely.
Use only Ford original Equipment floor mats. Do not stack multiple floor
mats over the Ford original equipment floor mats as they are not
positively retained.

REAR LIFTGATE

The liftgate area is only intended for cargo, not passengers. You can open
and close the liftgate from outside the vehicle. It cannot be opened from
inside the cargo area.
To open the liftgate window,
unlock the liftgate (with the key
or power door locks) and push
the key lock cylinder.
To open the liftgate, unlock the
liftgate and pull up on the handle
under the license plate lamp
shield.
To lock the liftgate and the liftgate
window, use the key or the power
door locks, depress the key lock cylinder or press the door lock switch
on the left side of the cargo area.
Controls and features
103