To exchange cutting heads, grasp the scissors as shown in
figure A with fingers at the side of the cutting head and the
hand away from the blades.
Press in on the sides of the cutting head and pull straight
To attach a cutting head, line it up with the body of the
scissors and push it on until it snaps into place. If the
cutting head does not line up easily, carefully separate the
blades from each other first then re-attach.
Protecting the environment
Should you find one day that your appliance needs
replacement, or if it is of no further use to you,
think of the protection of the environment. Black &
Decker repair agents will accept old Black &
Decker tools and ensure that they are disposed of
in an environmentally safe way.
Separate collection of used products and
packaging allows materials to be recycled and
used again. Re-use of recycled materials helps
prevent environmental pollution and reduces the
demand for raw materials.
Local regulations may provide for separate collection of
electrical products from the household, at municipal waste
sites or by the retailer when you purchase a new product.
Black & Decker provides a facility for the collection and
recycling of Black & Decker products once they have reached
the end of their working life. To take advantage of this
service please return your product to any authorised repair
agent who will collect them on our behalf.
You can check the location of your nearest authorised repair
agent by contacting your local Black & Decker office at the
address indicated in this manual. Alternatively, a list of
authorised Black & Decker repair agents and full details of
our after-sales service and contacts are available on the
Internet at: www.2helpU.com.
Black & Decker batteries can be recharged many
times. At the end of their useful life, discard
batteries with due care for our environment:
Run the battery down completely, then remove it from the
NiCd batteries are recyclable. Take them to any authorised
repair agent or a local recycling station.
Approx. charging time
EC declaration of conformity
Black & Decker declares that these products conform to:
Standards & Legislation.
98/37/EC, 89/336/EEC, 73/23/EC, EN60745, EN60335,
LpA (sound pressure) 77.1 dB(A),
LWA (acoustic power) 88.1 dB(A),
hand/arm weighted vibration 1.5 m/s2
KpA (sound pressure uncertainty) 3 dB(A),
KWA (acoustic power uncertainty) 3 dB(A)
Director of Consumer Engineering
Spennymoor, County Durham