Operation - Zenoah PSZ2610 Owner's Manual

PSZ2610

8. Operation

STARTING ENGINE
WARNING
The cutting head will start rotating upon the engine
starts.
1. Feed fuel and chain oil into their respective tanks
and tighten the caps securely.
(1)
(1) Fuel
2. Rest the unit on a flat, firm place. Keep the cutting
head off the ground and clear of surrounding objects,
as it will start rotating upon starting of the engine.
3. Push the primer pump several times until overflown
fuel flows out in the clear tube.
4. Move the choke lever to the closed position.
(1) Choke lever (2) Close (3) Open
GB-10
(2) Chain oil
(1)
(2)
(3)
5. Set the stop switch to the "-" position. Set the throttle
trigger to the start position (1 → 2 → 3).
Place the unit on a flat, firm place.
Keep the cutting head clear of everything around
it.
(1)
6. While holding the unit firmly, pull out the starter rope
quickly until engine fires.
WARNING
The product is equipped with a centrifugal clutch
mechanism, so the cutting attachment begins to
rotate as soon as the engine is started by putting
the throttle trigger into the start position. When
starting the engine, place the product onto the
ground in a flat clear area and hold it firmly in place
so as to ensure that neither the cutting part nor the
throttle trigger come into contact with any obstacle
when the engine starts.
IMPORTANT
• Avoid pulling the rope to its end or returning it by
releasing the knob. Such actions can cause starter
failures.
7. Move the choke lever downward to open the choke.
And restart engine.
(1) Stop switch
1
2
3
(1)
(1) Choke lever
(2) Close
(2)
(3) Open
(3)