Mercedes-Benz pmn Operator's Manual page 282

Operation
Engine compartment
Checking engine oil level with the
control system
When checking the oil level
the vehicle must be parked on level
ground
with the engine at operating tempera-
ture, the vehicle must have been
stationary for at least five minutes with
the engine turned off
with the engine not at operating tem-
perature yet, the vehicle must have
been stationary for at least 30 minutes
with the engine turned off
To check the engine oil level via the
multifunction display, do the following:
Switch on ignition ( page 33).
The standard display ( page 121) should
appear in the multifunction display.
Press button k or j on the
steering wheel until the following
message is seen in the multifunction
display:
280
One of the following messages will
subsequently appear in the indicator:
Engine oil level
OK
Add 1.0 qt engine oil
for max. oil level
(Canada: )
1.0 l
Add 1.5 qts engine oil
for max. oil level
(Canada: )
1.5 l
Add 2.0 qts engine oil
for max. oil level
(Canada: 2.0 l )
i
If you want to interrupt the checking
procedure, press the k or j
button on the multifunction steering
wheel.
If necessary, add engine oil.
For adding engine oil see ( page 281).
More information on engine oil can be
found in the "Technical data" section
( page 387) and ( page 390).
Other display messages
If the SmartKey is not turned to position 2
in the starter switch, the following
message will appear:
Switch ignition on to
check engine oil level
Switch on ignition ( page 33).