Table of Contents
Advertisement
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Set up each WPS connection between two devices. Both
devices must support WPS. See
Note: The VMG applies the security settings of the SSID1 profile (see
page
88). If you want to use the WPS feature, make sure you have set the security
mode of SSID1 to WPA2-PSK or No Security.
Click Network Setting > Wireless > WPS. The following screen displays. Select Enable and click
Apply to activate the WPS function. Then you can configure the WPS settings in this screen.
Figure 36 Network Setting > Wireless > WPS
The following table describes the labels in this screen.
Table 22 Network Setting > Wireless > WPS
LABEL
DESCRIPTION
General
WPS
Select Enable to activate WPS on this VMG.
Add a new device with WPS Method
Method 1
Use this section to set up a WPS wireless network using Push Button Configuration (PBC).
Select Enable and click Apply to activate WPS method 1 on the VMG.
WPS
Click this button to add another WPS-enabled wireless device (within wireless range of the
VMG) to your wireless network. This button may either be a physical button on the outside
of device, or a menu button similar to the WPS button on this screen.
Note: You must press the other wireless device's WPS button within two minutes of pressing
Method 2
Use this section to set up a WPS wireless network by entering the PIN of the client into the
VMG. Select Enable and click Apply to activate WPS method 2 on the VMG.
Chapter 7 Wireless
Section 7.9.9.3 on page 112
this button.
VMG1312-Bx0D User's Guide
96
for more information about WPS.
Section 7.2 on
Advertisement
Table of Contents
