Mercedes-Benz 2009 S-Class Operator's Manual page 414

Controls in detail
Panorama roof with power tilt/sliding panel
X
Switch on the ignition.
Opening
X
Opening manually: Press and hold the
roof panel switch to the resistance point in
direction of arrow 2.
X
Release the roof panel switch when the
desired position is reached.
X
Express operation: To open the tilt/
sliding panel completely, press the roof
panel switch past the resistance point in
direction of arrow and release.
2
X
Stopping during express operation:
Move the roof panel switch in any direction.
i
When the tilt/sliding panel is open,
resonance noises may result in addition to
the usual wind noises. They are caused by
minimal pressure changes in the passenger
compartment. To reduce or eliminate these
noises, change the position of the tilt/
sliding panel or open a window slightly.
412
Raising
X
Raising manually: Press and hold the roof
panel switch to the resistance point in
direction of arrow 1.
X
Release the roof panel switch when the
desired position is reached.
X
Express operation: To raise the tilt/
sliding panel completely, press the roof
panel switch past the resistance point in
direction of arrow and release.
1
X
Stopping during express operation:
Move the roof panel switch in any direction.
i Express raising is not available when the
tilt/sliding panel is open. The tilt/sliding
panel must be closed first.
Closing
X
Closing manually: Pull and hold the roof
panel switch to the resistance point in
direction of arrow 3.
X
Release the roof panel switch when the
desired position is reached.
X
Express operation: To close the tilt/
sliding panel completely, pull the roof panel
switch past the resistance point in
direction of arrow and release.
3
X
Stopping during express operation:
Move the roof panel switch in any direction.
Closing when the tilt/sliding panel is
blocked
G Warning!
Make sure that nobody can become
trapped and be seriously or even fatally
injured when closing the tilt/sliding panel
without automatic reversal function.
If the movement of the tilt/sliding panel is
blocked during the closing procedure (e. g. by
ice or pollution), the tilt/sliding panel will stop
and open slightly.
X
Immediately after the tilt/sliding panel has
stopped because it was blocked, pull the
roof panel switch in direction of arrow
until the tilt/sliding panel is fully closed.
If the tilt/sliding panel is blocked again and
opens slightly:
X
Immediately after the tilt/sliding panel was
blocked, pull the roof panel switch in
direction of arrow until the tilt/sliding
3
panel is fully closed.
3