Mercedes-Benz 2009 S-Class Operator's Manual page 131

While the characters are being selected as
described below, the top list entry
shows the destination which best
corresponds to the input data as it has been
entered up to that point.
At the same time, COMAND automatically
supplements characters entered by the
2
user with appropriate characters 3.
X
Changing language for the input
characters: Select !.
X
Select desired language.
X
Changing character set for the input
characters: Select #.
Depending on the previous setting, you will
change to letters with special characters or
to numbers with special characters.
X
Selecting characters: Slide
rotate ymz.
X
Confirming character selection:
Press n.
X
Deleting individual characters:
Select in the bottom line and press n.
)
X
Deleting an entire entry: Select
bottom line and press n until the entire
entry is deleted.
X Canceling an entry: Select Back in the
always
1 bottom line and press n.
or
X
Press back button
console ( Y
As soon as COMAND can clearly attribute the
characters entered to a destination, the input
characters
4
destination memory list without input
characters. Here you can confirm the current
entry or make another selection.
You can also manually switch to the
destination memory list without input
characters at any time.
X
Switching manually to the destination
memory list without input characters:
Slide qm.
or
omp
or
X
Select
d
bottom and press n.
in the
)
COMAND navigation system (entering a destination)
in the center
L
page 90).
disappear. You see the
in the second line from the
Control systems
Destination memory list without input
characters
X
Selecting a destination: Slide
rotate ymz.
X
Canceling selection: Press back button
in the center console (
L
or
X Select Back and press n.
The Back menu item is only present if this
i
list was called up from the list with input
characters.
X
Confirming selection: Press n.
X
Starting route calculation: Select
Start, see also (
Y page 127).
or
qmr
Y page 90).
Z
129