Table of Contents
Advertisement
Quick Links
Viper2000
Important Information
All persons authorised to use, repair or service the VIPER2000 tig
unit, should read the section on safety, before any work is under-
taken.
Further information is available in publication HSG118
'Electric safety in arc welding', which may be obtained from the
Health & Safety Executive. Please contact your distributor should
you not understand any of the information within this document.
INSTRUCTION MANUAL
To maintain continued developments of our products we reserve the right to alter specifications as quoted without prior notice
Newarc Ltd.
UK's Leading Manufacturer Of Welding Equipment
Newcastle +44 (0) 191 295 0111
Aberdeen +44 (0) 1224 771 063
www.newarc.co.uk
Description
TIG unit
Processes
03/14
Advertisement
Table of Contents
Related Manuals for NewArc Viper2000
Summary of Contents for NewArc Viper2000
- Page 1 Description TIG unit Processes Important Information All persons authorised to use, repair or service the VIPER2000 tig unit, should read the section on safety, before any work is under- taken. Further information is available in publication HSG118 'Electric safety in arc welding', which may be obtained from the Health &...
-
Page 3: Table Of Contents
4.3 - Contactor_____________________________________________________________ 4.4 - Arc Initiation___________________________________________________________ SECTION 5 — FAULT FINDING AND MAINTENANCE 5.1 - Maintenance__________________________________________________________ 5.2 - Fault Finding___________________________________________________________ SECTION 6 — ELECTRICAL DIAGRAMS 6.1 - System Diagram________________________________________________________ SECTION 7—PARTS BREAKDOWN 7.1 - Component Locations__________________________________________________ 7.2 - Parts List_______________________________________________________________ VIPER2000... -
Page 4: Section 1 - Safety
The safe handling of gas cylinders Pay attention to fire and safety regulations in force at the The VIPER2000 TIG units use argon gas during TIG welding. This is welding site. an inert gas and can displace oxygen in the atmosphere lead- ing to asphyxiation. -
Page 5: Section 2 - Specification
Note: - the Viper 2000 requires a suitable flow meter to be fitted to the pressure reduction regulator. Note: -The pressure reduction regulator should be set at approximately 5 Bar. VIPER2000... -
Page 6: Section 4 - Operation
This excellent striking characteristic is achieved by using state of the art elec- tronic techniques. As the arc ignition system does not require a spark gap for its operation it is virtually maintenance free. VIPER2000... -
Page 7: Section 5 - Fault Finding And Maintenance
Check that the supply voltage to the unit is in the range of 40 to 100 volts. Voltages outside this range may result in erratic operation or cause dam- age to the unit. VIPER2000... -
Page 8: Section 6 - Electrical Diagrams
SECTION 6 — ELECTRICAL DIAGRAMS 6.1 - System Diagram VIPER2000... -
Page 9: Section 7-Parts Breakdown
SECTION 7—PARTS BREAKDOWN 7.1 - Component Locations VIPER2000... -
Page 10: Parts List
HF bypass capacitor (3 per machine) Contactor M70070 HF inductor assembly M90479 Negative bus bar M90499 Positive bus bar M90500 Molded handle M00026 Mounting feet (4 per machine) M00096 Fuse 3.15 amp slow blow M00020 Torch switch plug M00063 VIPER2000... - Page 12 Newarc accepts no liability for correctness in respect of any impending change in legislation or health and safety requirements. Newarc also reserve the right to amend the detail of the docu- ment content without any notification to the consumer. If reference is made to Newarc while utilis- ing the document for spare parts purchase or instruction please advise the revision of the document to ensure correctness of information.