Initial Set-Up - Chaffoteaux & Maury BRITONY SX 14 FF Installation, Servicing And User's Manual

2.2 Initial Set-Up

IMPORTANT:
The installing technician should explain to the user how the water heater works, the safety devices it includes and how
to use it.
Before turning the water heater on, it should be connected to the electrical mains via a double pole isolating switch
with 3mm contact separation in both poles.
• Make sure that gas is supplied to the water heater (valve on gas pipe open) and purge any air as necessary
• Make sure that the electrical supply is turned on.
2.3 Use
Obtaining hot water
To turn on the water heater press the ON-OFF button (3 Fig.2). The water heater will come on automatically whenever a hot
water tap is turned on.
Selecting the power rating
Turn the power selector (Fig. 3) to the desired power rating.
The MAX position represents full power: 100%.
The MIN position represents minimum power: 50%.
Selecting the hot water temperature
Turn the water temperature selector (Fig. 4) to the desired water temperature.
The MAX position represents maximum temperature (minimum flow of water
through the appliance).
The MIN position represents minimum temperature (maximum flow of water
through the appliance).
Resetting the water heater
In the event that the water heater locks out due to an ignition fault, the red LED
(B Fig. 5) will light.
Wait for at least three minutes before resetting the appliance by turning the
appliance off, waiting 10 seconds and turning the appliance back on again by
pressing button A, (Fig. 5).
Should the appliance continue to lock out, isolate the electrical supply to the
appliance at the fused spur and contact a local service agent.
IMPORTANT: This water heater is not controlled by a thermostat. The temperature of the water depends on the flow of water
and the power setting. Too much flow will reduce the temperature achieved. Adjust the flow at the tap to
achieve the desired temperature.
Note: It is suggested that both the power rating and the temperature are adjusted to the minimum values necessary to meet your
requirements. In this way energy is saved and the working life of the appliance is extended, reducing the build-up of lime scale in
the heat exchanger.
Stopping the water heater
When you turn off the hot-water taps, the water heater stops automatically.
In order to turn off the water heater, press the ON-OFF button (3 Fig. 2).
4
F . 3
IG
F . 4
IG
A
B
F . 5
IG