7.3 Access to the Water Circuit
Important! Before any component is removed, the water heater must be drained of all water.
7.3.1 Drain down
1. Carry out step 7.1.1;
2. Turn OFF the cold water inlet tap on the appliance;
3. Place a container under screw P (Fig. 55) to catch any water;
4. Remove the screw P on the water valve (Fig. 55 & 56);
5. Turn ON the hot water outlet tap.
7.3.2 Removing the heat exchanger
1. Carry out steps 7.1.1 & 7.3.1;
2. Free the air pressure switch wires
from the heat exchanger by
removing the clip (Fig. 57);
5. Remove the two clips between the heat exchanger and the top of the
combustion chamber (Fig. 60 & 61);
F
IG
3. Unscrew
exchanger hot water outlet (Fig.
58);
F
. 57
IG
F
. 60
IG
. 55
the
nut
on
the
F
. 58
IG
F
. 61
IG
24
P
F
. 56
IG
4. Unscrew
the
exchanger water inlet (Fig. 59);
6. Pull the exchanger towards you
(Fig. 62);
7. Reassemble in reverse order.
nut
on
the
F
. 59
IG
F
. 62
IG