If the package has suffered rough handling, bumps or damage (visible or concealed), please note it on the bill of lading before accepting the delivery and contact Omcan within 24 hours, so we may initiate a claim with the carrier. A detailed report on the extent of the damage caused to the machine must be filled out within three days, from the delivery date shown in the shipping documents.
Si el paquete ha sufrido un manejo de poco cuidado, golpes o daños (visible o oculto) por favor anote en la factura antes de aceptar la entrega y contacte Omcan dentro de las 24 horas, de modo que podamos iniciar una reclamación con la compañia.
Safety and Warranty WARNING: The packaging components are classified as normal solid urban waste and can therefore be disposed of without difficulty. In any case, for suitable recycling, we suggest disposing of the products separately (differentiated waste) according to the current norms. DO NOT DISCARD ANY PACKAGING MATERIALS IN THE ENVIRONMENT! Technical Specifications Amps...
Operation 1. Turn the power to FULL power. 2. Set the conveyor speed on 4. 3. Allow warm-up time of 5 to 10 minutes. 4. Place a sample product on the conveyor belt to test the setting. A. If toasting is too light, turn conveyor speed control clockwise to a slow speed. B.
Maintenance power back on. 4. Switch the ON/OFF switch to the ON position, and turn conveyor to its fastest setting (Make sure the heater is off). 5. With the conveyor turned on and the crumb tray in place, take a wire grill brush or dry abrasive pad, clean the exposed surface of conveyor belt by passing the brush or pad, back and forth across the surface of the conveyor belt as the belt moves past (Figure 1).
Page 8
Maintenance not to catch on any internal components once put back into operating. Also, being sure to properly align the belt over the conveyor drive sprockets shown in Fig 3. NOTE: The direction of the belt. 7. Next, pull one end of the conveyor belt over the top of the sprockets, (being sure to line the links up properly with the sprockets) bring the two ends together.
Page 9
Maintenance 1. DISCONNECT POWER SOURCE. 2. After unit has cooled, remove the crumb tray and turn unit over so the bottom is facing upward. Never place unit on its side. 3. Remove the control box cover which contains the fan motor. 4.
Parts Breakdown Model CE-TW-3600 11387 Description Position Description Position Description Position Stainless Steel Cover Middle Insulation Plate IIVRIKOm Fan Terminal Conveyor Frame Indicator Light Insulation Plate Tray 14-16 T.O.D.36 F65 Front Plate Protection for Conveyor 17-19 390L 120V 1000W 38-2...
Warranty Registration Thank you for purchasing an Omcan product. To register your warranty for this product, complete the information below, tear off the card at the perforation and then send to the address specified below. You can also register online by visiting: Merci d’avoir acheté...
Page 20
Over the last 60 years, Omcan has grown to become a leading supplier to the food service industry in Canada and the USA. Our success over these many years is directly attributed to our established relationships with all of our valued customers and through providing them with Diverse, Dependable and Proven products.
Need help?
Do you have a question about the CE-TW-3600 and is the answer not in the manual?
Questions and answers