Operation Manual - Sharp MD-MT88H S Service Manual

Battery Power
Illustration: MD-MT88H
(For U.K.)
Checking the remaining amount of bat-
tery level
The remaining amount of battery level is shown by the
battery indicator ( ) during operation.
When the battery is completely discharged, the bat-
tery indicator will flash. Recharge the battery or
replace the alkaline battery with a new one.
When the battery has run completely out, "BATT
EMPTY" will appear. Then, the power will be discon-
nected automatically.
Notes:
If you use the battery which you stopped charging
halfway, " " may appear. It does not mean that the
battery is completely charged.
The battery indicator will not correctly display the
remaining capacity for approximately 10 seconds after
the power has been turned on.
When the AC adaptor or a separately available car
adaptor is used, the battery indicator will not be
shown.
The number of bars shown in the battery indicator may
increase or decrease, depending on the operation
being performed. This is normal.

OPERATION MANUAL

Charging the rechargeable battery
When the rechargeable battery is used for the first
time or when you want to use it after a long period
of disuse, be sure to charge it fully.
1
Insert the rechargeable battery.
A rechargeable battery other than the AD-N70BT
cannot be charged.(MD-MT88H)
A rechargeble battery other than the one supplied
or the optional one (AD-N70BT) cannot be
charged.(MD-MT99H)
2
Plug the AC adaptor into the wall socket,
and then insert the plug on the other end
into the DC IN 5V socket.
3
Press the MODE/CHRG button.
" " will flash, and battery will begin charging.
After the rechargeable battery is charged or used, it
will get slightly warm. This is normal.
When the portable MD is turned on or operating, the
battery will not be charged.
AC 220-230V
50/60 Hz
(For Europe)
Using with the rechargeable or alkaline
battery
1
Disconnect the AC adaptor.
2
Insert the rechargeable bat-
tery or alkaline battery from
the (+) marked side.
Use a commercially available LR6,
"AA" size alkaline battery.
Notes:
Setting the volume level to "0" whilst recording with the
rechargeable or an alkaline battery reduces the bat-
tery drain.
When you do not use the unit for hours, remove the
battery. (The battery drains gradually even when the
power is turned off.)
Carry the battery in the supplied case.(MD-MT99H)
This unit can be used with the AC adaptor when the
rechargeable or an alkaline battery is in the unit.
Caution:
Do not use a nickel-cadmium battery.
– 7 –
MD-MT88H/99H