Rear Panel - Denon MC4000 User Manual

4. Split Cue: When this switch is in the On position, the headphone audio will be "split" such
that all channels sent to cue channel are summed to mono and sent to the left headphone
channel and the master mix is summed to mono and sent to the right channel. When the
switch is in the Off position, the cue channel and master mix will be "blended" together.
5. Mic EQ: Turn these knobs to boost or cut the high and low frequencies for the
corresponding microphones.
6. Mic Echo Level: Turn this knob to adjust the amount of the reverb effect on the
microphones' audio signal.

Rear Panel

2
3 4
1
1. Power Input: Use the included power adapter (5 VDC, 3 A, center-positive) to connect this
input to your power source.
2. Cable Restraint: You can secure cables to this restraint to help avoid disconnecting them
accidentally.
3. Power Button: Press this button to power MC4000 on or off. Power on MC4000 only after
you have connected all of your input devices and before you power on your amplifiers and
loudspeakers. Power off your amplifiers and loudspeakers before powering off MC4000.
4. USB Port: Use a standard USB cable (included) to connect this USB port to an available
USB port on yoru computer. This connection sends and receives audio and control
information to and from the computer.
5. Master Outputs (XLR, balanced): Use standard RCA cables to connect these outputs to
loudspeakers or an amplifier system. Use the Master knob on the top panel to control the
volume level.
6. Master Outputs (RCA, unbalanced): Use standard RCA cables to connect these outputs
to loudspeakers or an amplifier system. Use the Master knob on the top panel to control
the volume level.
7. Stereo/Mono: Use this switch to set the channel configuration of the Master Outputs:
Stereo (binaural audio using separate left and right channels) or Mono (summed monaural
audio through both left and right channels).
8. Booth Outputs (1/4" / 6.35 mm): Use standard RCA cables to connect these outputs to
booth monitors or a booth amplifier system. Use the Booth knob on the top panel to
control the volume level.
9. Aux Inputs: Use standard RCA cables to connect these line-level inputs to an external
audio source (smartphone, tablet, media player, etc.). Use the Aux knob on the top panel
to control the volume level.
10. Mic 1 Input (XLR or 1/4" / 6.35 mm): Use a standard XLR or 1/4" (6.35 mm) cable (not
included) to connect a standard dynamic microphone to this input. Use the Mic 1 Volume
knob on the top panel to control the volume level.
11. Mic 2 Input (1/4" / 6.35 mm): Use a standard 1/4" (6.35 mm) cable (not included) to
connect a standard dynamic microphone to this input. Use the Mic 2 Volume knob on the
top panel to control the volume level.
®
12. Kensington Lock: Use this slot to secure MC4000 to a table or other surface.
5
8
12
9
6
7
11
10
7