Changing Time Display; Recall Memory - American Audio Radius 2000 User Manual And Reference Manual

BASIC OpERATIONS (CONT.)
TIME BAR INDICATOR (50) - Details the time defined in the time meter (51) as a visual bar icon. As with
the time meter (51) this bar is also dependent on the selected time function [remain or elapSed]. This
bar will begin to flash when a track is ending regardless
bar as a visual reminder that a track is ending.
SYSTEm mEmORY

16. RECALL mEmORY:

The Radius 2000 can store 4 programmed cue points per folder and effect parameters in to mem-
ory. These setting may be recalled at any time, even when a media source has been removed
and loaded at a later time. To recall the memory on a specific media source; 1) Be sure a media
source is not loaded. 2) Press the memory Button (30) down until the memory button LED begins to
flash. 3) Load the media source. "RECALL" will appear in the VFDfd (3) while the memory is being
installed and the memory button LED will turn off.
©
15. CHANgINg THE TImE mETER (51)/TImE BAR (50):
DURING NORMAL PLAYBACK, pressing the time Button (32), will change the
time display information (50 & 51) in the Vfd (3). The following is a break down
of the time settings and their definitions:
1) ELAPSED - This describes the time in the VFD (3) as the current TRACKS
Elapsed running time.
2) REMAIN - This describes the time in the VFD (3) as the current TRACKS
remaining running time.
Figure 31
American Audio - www.AmericanAudio.us - Radius 2000™ Instruction Manual Page 26
®
of which time func
t
i
on you are in. Use the flashing