American Audio Radius 2000 User Manual And Reference Manual page 13

gENERAL fUNCTIONS AND CONTROLS (Cont.)
other.
pAN EffECT - This button is used to activate and deactivate the Trans or Pan effect. The Pan effect
allows you to pan the output from the left channel to the right channel. See built-in effects on page 31.
REVERSE - This button activates reverse play mode This function will play your track or sample in re-
verse. All pitch and effect functions will operate normally in this mode
27. SAmpLE BUTTON - This button is used to set and store a sample. Press this button and then press your
desired Bank Button (28) to set the sample loop mode, the button LED will glow.
When sample mode is set, the sampler will mix the music together. Press the Sample button again to set the
sample single mode (LED is flash). Press the Sample button again to cancel the sample function.
28 BANk BUTTONS 1-4 - These buttons are used to store either four (4) cue points or four (4) samples. Each
Bank Button can store either a sample or a cue point. To play your programmed samples, press the Sample
Button (27) and then press the Bank program Button.
29. BANk pROgRAm BUTTON - This function will allow you to program a sequence of up to 12 saved
samples. See page 25 for more information.
30. mEmORY BUTTON - This button can be used in a couple ways:
Press this button to activate the Memory mode, the memory button LED will glow when active. After the
memory mode is activated, press your desired Bank Button (28) to store your CUE point or playing loop. See
Using Built In Sampler on page 23.
You can also record a loop by pressing the BANK button during music playback to start recording, when you
have reached your desired loop ending point, press the BANK button again.
You can also memorize the BANKS to the playing folder with your SD/USB device by pressing the MEMORY
button for 1 sec. To recall the BANK, press the MEMORY button (LED On), and turn the folder knoB (20)
to select the Folder with the BANKS that you would like to recall.
31. pARAmETER TImE kNOB - This knob is used to adjust the parameter time value. You can also push the
TIME KNOB and turn the jog Wheel (9) to adjust the parameter time value.
32. TImE BUTTON - The button will switch the time value described in the time meter (51) between ELAPSED
PLAYING TIME, and TRACK REMAINING TIME.
33. SgL/CTN - This function allows you to choose between single track play or continuous track play (all tracks
in order). This function also operates in FLIP-FLOP mode. With this button you can also switch AUTO CUE on
and off, by pressing it for at least 1 second.
©
American Audio - www.AmericanAudio.us - Radius 2000™ Instruction Manual Page 13
®