Connection Method; Inactivity Timeout - Option Audio Xyfi User Manual

APN Username and Password
Leave Emtpy if APN address does not require username and password.
Username: To be filled in if your APN is associated with a 'Username' (defined by your SIM provider).
Password: To be filled in if your APN is associated with a 'Password' (defined by your SIM provider).
Network Type
Choose 2G or 3G as network type
Depending on the version, mobile networks support different transmission technologies. You can define your preferred
transmission technologies using the 'Network Selection' option. The following facilities are available:
Automatic: XYFI independently determines the fastest transmission method and adapts the settings accordingly.
3G only: XYFI always uses 3G fast access via HSPA (High Speed Packet Access) or UMTS (Universal Mobile
Telecommunications System). However, these are not available everywhere. If this setting has been activated, no
connections will be made via 2G!
2G only: XYFI will always use EDGE (Enhanced Data Rates for GSM Evolution) or GPRS (General Packet Radio Service)
Internet connections. This is slower than 3G, but are available almost everywhere. If this setting is activated, no
connections will be made via 3G!

3.2.3 Connection Method

Choose your connection method
XYFI lets you change the connection method to suit your needs.
Connection method gives you the following choices:
Manually: Connect to the Internet by clicking 'Connect' on the Connection Status page in the management console. You
can also establish or terminate the connection (physically), by pushing the LED button for less than 1 second.
Automatic upon traffic: XYFI will automatically connect when you attempt to send data via the Internet.
Always connected: XYFI will connect to Internet as soon as it is powered up and will stay connected until it is powered
down.
Please note that in order for your changes to take place, you need to click the 'Save Changes' button.

Inactivity timeout

(in minutes)
In case of inactivity the XYFI will disconnect after your set timing.
You have to insert the inactivity time in minutes. Set it to 0 (zero) if you want the Internet to stay connected all the time.
The maximum is 1440 minutes (24 hours). Incoming traffic is treated as inactivity.
Auto Connect when Roaming
When travelling out of the country or operating near a country border you could be in a roaming situation. Roaming charges
will apply and certain networks are more expensive than others.
If you do not want the XYFI to Auto Connect in roaming situations, please click the 'No' button (remember to Save Changes).
3.2.4 Mobile Network Usage
Here you get an usage statistics overview of your XYFI.
Current Session: The time and amount of data downloaded/uploaded within this session.
Current Month: The time and amount of data downloaded/uploaded within this month. Monthly counter will automatically be
reset on the 1st of each month.
Total Usage: The total time and amount of data downloaded/uploaded.
It is possible to erase all the statistics back to '0', by clicking the 'Reset Statistics' button.
Note: The usage/time overview displays approximate values only.
3.2.5 Manage PIN
Enable/Disable your PIN number
You can lock your SIM card (enabled) so that it can not be used without a Personal Identification Number (PIN). You must then
enter the PIN each time you turn on the XYFI.
You can deactivate the PIN request by using the 'Disable' option.
Enter your PIN number
Please enter a SIM card PIN code (ex. 0234)
Where can I find my PIN number?