Portable Wireless AP/Router
3.4 WISP Mode
In this mode, you do not need to configure the signal
transmitter but only to simply configure the W150M to
amplify the wireless signal and multi computers can share
the internet. The device supports DHCP function to assign
IP addresses automatically and NAT function. If you enable
the WISP outside the house but the inside WISP AP signal
is poor, the device can enhance the signal and improve the
speed. If more than one wired computer access, you can
connect the LAN port of the device to the switch and the
switch to the computer.
The network topology is as follows.
More details please refer to 5-4.