Information Codes - Samsung DV56H9100E Series User Manual

probleM
Shuts off before load is dry
lint on clothes
Garments still wrinkled after
Wrinkle release
odors remain in clothing
after air fluff.

InformatIon coDES

Information codes may be displayed to help you understand what is occurring with your dryer better.
error
display
te
he
de
Fe
9e1
ae
eee
dF
be2
For any codes not listed above, call 1–800–726–7864 (1–800–SAMSUNG)
DV9100HA DRY_DV56H_USER MANUAL_DC68-03170K-01_EN.indd 33
soluTion
• The dryer load is too small. Add more items or a few towels and
restart the cycle.
• The dryer load is too large. Remove some items and restart the dryer.
• Make sure the lint filter is cleaned before every load. With some loads
that produce high amounts of lint, it may be necessary to clean the
filter during the cycle.
• Some fabrics are lint producers (for example, a fuzzy white cotton
towel) and they should be dried separately from clothes that are lint
trappers (for example, a pair of black linen pants).
• Divide larger loads into smaller loads for drying.
• Check pockets thoroughly before washing and drying clothes.
• Small loads of 1 to 4 items work best.
• Load fewer garments. Load similar-type garments.
• Fabrics containing strong odors should be washed in a normal cycle.
Meaning
The thermistor resistance is very low or
high.
Invalid heating Temp when the dryer is
running.
Running the dryer with door open.
Invalid power source frequency.
Electronic Control Problem.
(Over Voltage Error)
Electronic Control Problem.
(Communication Error)
Invalid state of Eeprom Communication. Call for service.
Invalid door.
Unit detects a button is being pressed
for over 30secs or button is stuck.
Clean the screen or vent.
If the problem continues, call for service.
Call for service.
Close the door and then restart.
If the problem continues, call for service.
Try restarting the cycle.
If the problem continues, call for service.
Call for service.
Call for service.
Call for service.
Make sure a button is NOT being pressed
continuously. Try restarting the cycle.
If the problem continues, call for service.
English - 33
soluTion
2014-2-26 10:25:46