Ford 2013 Explorer Owner's Manual page 342

Hide thumbs Also See for 2013 Explorer:

Table of Contents

horizontal line on the plain surface (1) at this height (masking tape

works well).

3. Turn on the low beam headlamps to illuminate the wall or screen and

open the hood. To see a clearer light pattern for adjusting, block the

light from one headlamp while adjusting the other.

For vehicles with halogen headlamps:

For vehicles with HID headlamps:

4. Open the hood.

2013 Explorer (exp)

Owners Guide gf, 2nd Printing

• (1) 8 feet (2.4 meters)

• (2) Center height of lamp to

• (3) 25 feet (7.6 meters)

• (4) Horizontal reference line

2. The center of the headlamp has a

3.0 millimeter circle on the lens.

Measure the height from the center

of your headlamp to the ground (2)

and mark an 8 foot (2.4 meter) long

On the wall or screen you will

observe a flat zone of high intensity

light located at the top of the right

hand portion of the beam pattern. If

the top edge of the high intensity

light zone is not at the horizontal

reference line, the headlamp will

need to be adjusted.

There is a distinct cut-off (change

from light to dark) in the left

portion of the beam pattern. The

top edge of this cut-off should be

positioned two inches (50.8

millimeters) below the horizontal

reference line.