Ford 2013 Explorer Owner's Manual page 186

186 Universal Garage Door Opener
Fixed code programming
Note: It may be helpful to have another person assist you in
programming the transmitter.
When the switch is in the up, on, or + position, mark down "left button".
When the switch is in the middle, neutral, or 0 position, mark down
"middle button".
When the switch is in the down, off, or – position, mark down "right
button".
into the system by pressing and releasing the buttons corresponding to
the settings you noted.
5. Simultaneously press and release all three function buttons. The LED
lamps will illuminate.
7. When the garage door moves, release the button within one second.
When the button is released, the LED lamp will flash slowly.
2013 Explorer (exp)
Owners Guide gf, 2nd Printing
USA (fus)
To program units with fixed code
DIP switches, you will need the
garage door hand-held transmitter,
paper and a pen or pencil.
1. Switch the ignition on.
2. Open the battery cover and note
all the switch settings from left to
right.
3. Press all three function buttons
simultaneously for a few seconds
and then release. The LED lamps
will flash slowly.
Note: The following step must be
completed within 2.5 minutes.
4. Enter the corresponding DIP
switch settings from left to right
6. Press and hold the function
button you would like to use to
control the garage door.
Note: You may need to hold the
button from 5–55 seconds before
observing movement of the garage
door.