Advertisement
IMPORTANT! Before assembly or each use, inspect this product for
damaged hardware, loose joints, missing parts or sharp edges. DO NOT
use if any parts are missing or broken. Contact Mattel for replacement
parts and instructions if needed. Never substitute parts.
Motor Assembly
1
• While pressing the buttons on the motor assembly tubes, fit it onto
the straight end of each upper leg.
Hint: You may need the help of another adult.
PRESS
2
• While pressing the button on the end of a lower leg, fit it into the
short end of an upper leg. Continue to push the lower leg until it
"snaps" into the hole.
• Repeat this procedure to assemble the other lower leg to the other
upper leg.
PRESS
Upper Legs
Lower Legs
PRESS
Assembly
3
• Pull apart the legs.
• Lift the free end of the frame support bar.
• Fit the hole in the frame support bar over the peg on the opposite
leg. Push to "snap" the frame support bar in place.
4
• Fit the seat back hubs into the slots in the seat bottom.
Hint: The seat back hubs only fit one way. If they do not seem to fit,
try the other slot.
5
BOTTOM VIEW
• Turn the seat bottom face down.
• Insert four #8 x 1,9 cm screws into the holes in the seat and tighten
with a Phillips screwdriver.
• Turn the assembly upright.
3
Frame Support Bar
Seat Back Hubs
Seat Bottom
Advertisement
