Switching On And Off - Black & Decker LSW36 Instruction Manual

NOTE: Ensure thesweeper isswitched offand thebattery i s
removed before a ttaching orremoving thesweeper tubes. The
tube assembly must beassembled tothehousing before u se.
• TUBE ASSEMBLY: Toattach t heinner t ube tothesweeper, line
upthetube with thesweeper housing asshown i nfigureD.Push
thetube into thesweeper housing until thelock button engages
thelock hole inthetube. R epeat thisprocess fortheouter tube.
SWITCHING ONAND OFF (FIGURE
E}
ZLWARNING-
USE BOTH HANDS TO GRiP THE PRODUCT
FIRMLY WHEN SWiTCHiNG ON.
To switch the sweeper on, slide the on/off
switch forward.
To switch the sweeper off, slide the on/off
switch back.
Z_CAUTION-
DO NOT POINT UNIT
DISCHARGE AT SELF OR BYSTANDERS.
ALWAYS WEAR SAFETY GLASSES. WEAR A FILTER MASK IF
THE OPERATION IS DUSTY. USE OF RUBBER GLOVES AND
SUBSTANTIAL FOOTWEAR IS RECOM MEN DED WHEN WORKI NG
OUTDOORS. FOR HOUSEHOLD USE ONLY.
Z_WARNING: CUT HAZARD. When turning the tool off for tube
installation or any other reason, wait 10 seconds for the fan to stop
rotating before disassembly.
• Always switch off and remove the battery when:
• The power supply cord has become damaged or entangled.
• You leave sweeper unattended.
• Checking, adjusting, cleaning or working on sweeper.
Use sweeper only in daylight or good artificial light.
POWER COMMAND (FIGURE F)
MAX POWER / MAX RUNTIME
The max power / max runtime feature
(F1) is located on the toot handle.
It allows you to optimize the tools
performance and boost the power as
needed.
• To choose max power, rotate dial to
setting 6.
• To maximize runtime rotate dial to setting 1.
• For a combination of both, rotate dial to setting from 2 to 5.