Burner And Nozzle Specifications - Indesit K6T52S/I Installation And Use Manual

c) Minimum regulation of the hob burners:
• Turn the tap to minimum;
• Remove the knob and adjust the regulation screw,
which is positioned in or next to the tap pin, until the
flame is small but steady.
NB.: In the case of liquid gas, the regulation screw
must be screwed in all the way.
• Check that the flame does not go out when you turn
the tap quickly from high to low.
d) Regulating the primary air of the burners: the primary
air of the burners does not need to be regulated.
Table 1
Burner Diameter
(mm)
Fast
100
(Large)(R)
Semi Fast
75
(Medium)(S)
Auxiliary
55
(Small)(A)
Triple Ring
130
(TC)
Nominal (mbar)
Supply
Minimum (mbar)
Pressures
Maximum (mbar)
* At 15°C and 1013 mbar- dry gas
** Propane P.C.S. = 50,37 MJ/Kg
*** Butane P.C.S. = 49,47 MJ/Kg
Natural P.C.S. = 37,78 MJ/m
S R
TC A
K6T52S/I

Burner and Nozzle Specifications

Thermal Power By-Pass
kW (p.c.s.*) 1/100
Nominal Reduced (mm)
3,00 0,7
1,90 0,4
1,00 0,4
3.25 1.5
3
Important
On completion of this operation, replace the old rating
sticker with one indicating the new type of gas used. This
sticker is available from our Service Centres.
Note
Should the pressure of the gas used be different (or vary)
from the recommended pressure, it is necessary to fit a
suitable pressure regulator onto the inlet pipe in compli-
ance with current standards regarding "regulators for chan-
nelled gas.".
Liquid Gas
Nozzle
1/100
(mm) ***
41 86 218
30 70 138
30 50 73
63 91 236
28-30
20
35
17
Natural Gas
Flow* Nozzle
g/h 1/100
** (mm)
214 116
136 106
71 79
232 133
37
25
45
Flow*
l/h
286
181
95
309
20
17
25