GETTING STARTED
NOTE:
Radio Batteries
Install the 8 AA-size alkaline batteries in the
transmitter making sure the positive(+) and
negative (-) ends are oriented correctly. Use only
quality alkaline or rechargable Ni-Cad batteries.
5 cell Receiver Pack
Note: Your Muggy is equipped with a rechargable receiver pack
installed in your truck. Follow the instructions to remove or
replace the receiver pack.
To remove or charge the battery pack remove the two
clips securing the reciever box cover. Unplug the
battery from the switch. Remove the battery from the
receiver box.
Before you start your Muggy, read your engine break-in and operating instructions.
If you run your Muggy without following proper break-in procedure, you may damage
or fail to get maximum performance from your engine, and void the warranty.
Antenna Tube
Locate the antenna tube in the plastic bag with the
Operations guide. Thread the black antenna wire through
the mounting boss on top of the receiver box cover and
through the antenna tube. Push the antenna tube into the
mounting boss and attach the antenna cap.
Charging the Receiver Pack
Plug the AC charger into the proper wall
receptacle (110V). Plug the battery pack into
the charger. When the battery is charging the
red indicator light will be on. The battery must
be charged for 12 hours to attain full charge.
Page 1