Basic Operations - Macrom M-DVD5542R Owner's Manual

Basic Operations

Turn on/off the power
1. Press POWER button to turn on the unit.
The unit goes back to the last status after
power on.
2. When on, press POWER button to turn off
the unit.
Mute
Press to cut the sound.
Note:
• Pressing again or adjusting volume will
release muting.
• MUTE appears on the TFT during muting.
Adjust the volume
Press VOL +/- to increase or decrease the
volume level.
The adjustable range of volume is 0 to 39.
Playing source selection
Method 1:
Press SRC button on the panel or remote
control to cycle through all the available
sources.
Method 2:
Open the 'SOURCE MENU' by touch SRC at
the top left corner of the TFT or press MODE
button on remote control, and then touch the
option you desired or select the option by
moving the cursor and then confirm.
Note:
• When some devices are not ready, they
cannot be selected.
• You should stop switching when the playing
source you desired has been selected and
wait for some seconds, the unit will auto
enter the playing source mode you have
selected.
When parking brake applied
1. If 'PRK SW' cable is connected to hand
brake switch, the video display of the TFT
monitor will be controlled by driving status,
system setup and input video sources.
2. When the car is moving ahead, if the
video disc is played, the screen appears
"WARNING!! Engage Parking Brake to
View Video", and blank screen. The above
warning screen will prevent the driver
watching images. The passengers at the
rear seats can watch normally.
7